Industry Education that Everyone Benefits From
This training will cover your basic Industrial Hydraulic Technology subjects. Our curriculum was built with rising professionals in mind and provides the standard principles of hydraulics, allowing students to better understand how to service, diagnose, repair, and build hydraulic based equipment/systems.
Basic Hydraulic Course Curriculum:
- Review of Basic Physics and Terminology
- Basic Components & Symbols
- Pumps (Gear, Vane & Piston)
- Piston Pump Controls
- Hand’s on training with test stand
- Pressure Controls
- Flow Controls and Check Valves
- Load Holding Valves
- Directional Valves
- Specialty Valves (Servo, Proportional & Din Logic)
- Hydraulic Filtration
- ISO Codes
- Filter Beta Ratings
- Nominal and Absolute Filter Elements
- Fluid Sampling procedures
- Circuit Review/Trouble Shooting
This is a Level – 1 training course, more courses are soon to come.
Training Where You Need It, When You Need It
Training takes place at one of the following Hyspeco locations:
- St. Louis, MO
- 2053 Congressional Dr, St. Louis, MO 63146
- Wichita, KS
- 1729 South Sabin St, Wichita, KS 67209
We also provide training ON-SITE at your location. With this option training can be scheduled based on your needs and is most cost effective when looking to train eight employees or more. On-site training provides a familiar learning environment and enables our instructor to asses and assist our students in the direct diagnoses, repair and design of your hydraulic equipment.
The price for this course is $550 for a two day training, lunch is included each day, and a Parker industrial hydraulic technology training booklet will be given to each attendee. Training will take place on and at the following locations:
- October 15th & 16th, 2018
If you are an attendee of a Hyspeco training classes, you get priority specialist consulting services with our very own specialist Dave Granade! Dave has over 42 years of fluid power experience, and has an incredible amount of knowledge in the area of cost savings, machine maintenance, hydraulic efficiency, prevention of equipment downtime, and more.
On-Site Assistance For Any Size Job
With over 42 years of experience, Dave Granade provides industry leading customer support. Knowledgeable in almost every aspect of Hydraulic/Pneumatic equipment our consulting services are available for any fluid power situation. Consulting is done on-site – working with the Customer’s personnel on system design, supervising and directing maintenance personnel, reviewing schematics, training, and more.
Typical billing is $200/hour or $1500/day and may include, but not limited to, the following services:
- Performing Service
- Machine Diagnosis
- Installation of Components
- HPU Start Ups/Machine Set Up
- Cylinder Modifications
- Hydraulic Repair
- Set Up and Training Air/Oil